P082D
Gear Lever Y Position Sensor 1 Circuit Range/Performance
Transmission / gear selector
Generic OBD-II
Medium
What it means
P082D means the transmission control module sees a signal from the gear lever Y position sensor that is outside its expected range. This sensor reports where the shift lever sits, so a faulty reading can cause harsh shifts or a limp mode. The engine still starts and runs — this is a selector-signal fault, not an engine problem.
Medium
Can I keep driving? Usually drivable, but the transmission may shift harshly or drop into a limited limp mode — get it checked soon.
Common symptoms
What you'll notice
- Check-engine light on
- Harsh or unexpected shift shock
- Gear selector position reads incorrectly or intermittently
- Transmission may enter limp mode or hold a single gear
Common causes
Most likely first
- Wiring or connector fault at the gear lever Y position sensor (open, shorted, or corroded)Likely
- Poor electrical connection in the sensor circuitCommon
- Faulty gear lever Y position sensorCommon
- Failed transmission control module (rare)Less often
How to diagnose & fix
Work through it in order
- Read freeze-frame data and inspect the gear lever Y position sensor connector for damage, corrosion, or a loose pin.
- Check the sensor's signal, supply, and ground circuits for continuity and correct voltage with a multimeter.
- Compare the sensor's reading against actual lever position to confirm it tracks correctly.
- Replace the position sensor if its signal is out of range with wiring confirmed good. Clear and re-test.
FAQ
Quick answers
Is it safe to drive with P082D?+
Short trips are usually fine, but the transmission may shift roughly or limit itself. Have it diagnosed before the fault worsens.
Can I just clear P082D?+
It will clear, but it returns once the selector position signal goes out of range again until the sensor or wiring is fixed.
Related codes
Often seen with P082D
Read & clear P082D yourself
Scan your car, confirm the code, and clear it once it's fixed — with OBD DashX on your phone.
✓ Verified name — SAE J2012 / ISO 15031-6Guidance reviewed by OBD DashX