Invalid Data Received From Steering Angle Sensor Module
What it means
U0428 is a network communication code: a module is receiving data from the steering angle sensor that is corrupt, out of range, or implausible. This sensor tells the car which way and how fast you're steering, and stability control, traction control, and steering assist rely on it. Invalid data usually disables those safety features, so the car handles normally in easy conditions but won't help you in a skid until it's repaired.
Can I keep driving? Drivable, but stability control, traction control, and lane/steering assist may switch off — drive with extra care until fixed.
Common symptoms
What you'll notice
- Stability control (ESC), traction control, or ABS warning lights on
- Steering-assist or lane-keeping features disabled
- Warning message about stability or steering systems
- Other network warning lights at the same time
Common causes
Most likely first
- Internal fault in the steering angle sensor module sending corrupt dataLikely
- Sensor not calibrated after an alignment, repair, or module replacementCommon
- Wiring or connector problems on the bus to the sensor moduleCommon
- Low system voltage or a poor ground affecting the sensorLess often
How to diagnose & fix
Work through it in order
- Scan all modules and record freeze-frame data; clear any lost-communication codes first.
- Perform a steering-angle sensor calibration (zero-point reset) with a capable scan tool.
- Check battery voltage and the sensor's ground.
- Inspect the sensor connector and bus wiring for corrosion or loose pins.
- If calibration and wiring are good, suspect the steering angle sensor module and confirm with manufacturer tests.
FAQ
Quick answers
Is it safe to drive with U0428?+
Can I just clear U0428?+
Related codes
Often seen with U0428
Read & clear U0428 yourself
Scan your car, confirm the code, and clear it once it's fixed — with OBD DashX on your phone.