DOBD DashX ☰ Browse all codes
P2746

Intermediate Shaft Speed Sensor B Circuit Range/Performance

Transmission Generic OBD-II Medium

What it means

P2746 means the transmission control module sees an implausible or out-of-range signal from the "B" intermediate shaft speed sensor, which reports how fast an internal shaft is turning. Bad speed data can cause erratic or harsh shifting and limp mode. It's usually a sensor, tone-ring, or wiring fault; the engine still starts and runs.

Medium

Can I keep driving? Drivable but may shift erratically or enter limp mode β€” the engine starts and runs fine; get it checked.

Common symptoms

What you'll notice

Common causes

Most likely first

  1. Faulty intermediate shaft speed sensor B
  2. Metal debris on the sensor tip or a damaged tone/reluctor ring
  3. Wiring or connector fault (intermittent or high resistance)
  4. Low or dirty transmission fluid affecting readings
  5. Faulty TCM (rare)

How to diagnose & fix

Work through it in order

  1. Read freeze-frame and compare intermediate, input, and output shaft speeds.
  2. Inspect the sensor and its connector; check for metal debris on the tip.
  3. Check the wiring for shorts, opens, or high resistance.
  4. Verify transmission fluid level and condition.
  5. Replace the speed sensor if the signal is out of range; clear and road-test.

FAQ

Quick answers

Is it safe to drive with P2746?+
Usually yes, but bad speed data can cause harsh or wrong-gear shifts and limp mode. The engine runs fine β€” get the sensor checked before it strands you in a fixed gear.
Can I just clear P2746?+
It returns once the transmission sees an implausible speed signal again. Fix the sensor, tone ring, or wiring to clear it for good.

Related codes

Often seen with P2746

Read & clear P2746 yourself

Scan your car, confirm the code, and clear it once it's fixed β€” with OBD DashX on your phone.

β–Ά Get it on Google Play
βœ“ Verified name β€” SAE J2012 / ISO 15031-6Guidance reviewed by OBD DashX