Ignition Coil 'H' Primary Control Circuit High
What it means
P2322 means the ECM saw higher-than-expected voltage (an open or high-resistance condition) on the primary control circuit for ignition coil 'H'. Because that coil may not fire correctly, the cylinder it serves can misfire, causing rough running and lost power. The usual causes are an open or corroded connection, a bad connector, or a failed coil. Repair it soon to avoid catalytic-converter damage from a sustained misfire.
Can I keep driving? Usually yes, but expect a misfire and rough running on that cylinder; sustained misfiring can damage the catalytic converter, so repair it soon.
Common symptoms
What you'll notice
- Check-engine light on, sometimes flashing during a misfire
- Rough idle and an intermittent stumble or miss
- Hesitation and reduced power on acceleration
- Slightly higher fuel consumption
Common causes
Most likely first
- Open or high-resistance connection in the coil 'H' primary control wiringLikely
- Poor or corroded connection at the coil connectorCommon
- Faulty ignition coil 'H' (primary winding)Common
- Broken or backed-out terminal in the harnessLess often
- Failed ECM ignition driver, least likelyLess often
How to diagnose & fix
Work through it in order
- Read freeze-frame data and note which cylinder coil 'H' serves.
- Inspect the coil connector and primary control wiring for an open circuit, corrosion, or a loose terminal.
- Measure the coil's primary winding resistance against spec.
- Swap the suspect coil with a neighbouring cylinder to see if the fault follows it.
- Repair the connection or replace the coil, then clear the code and re-test.
FAQ
Quick answers
Is it safe to drive with P2322?+
Can I just clear P2322?+
Related codes
Often seen with P2322
Read & clear P2322 yourself
Scan your car, confirm the code, and clear it once it's fixed — with OBD DashX on your phone.