DOBD DashX ☰ Browse all codes
P0715

Input/Turbine Shaft Speed Sensor A Circuit

Transmission speed sensor Generic OBD-II High

What it means

P0715 means the transmission control module isn't getting a proper signal from the input/turbine shaft speed sensor, which reports how fast the transmission's input side is turning. Because the module uses this to time and control shifts, a fault typically causes harsh or erratic shifting and often forces the transmission into a limp (fail-safe) mode.

High

Can I keep driving? Drive gently and briefly β€” without turbine speed input the transmission often shifts harshly or locks into limp mode. Prolonged driving can add wear, so fix it promptly.

Common symptoms

What you'll notice

Common causes

Most likely first

  1. Faulty input/turbine speed sensor
  2. Sensor wiring or connector damaged, shorted, or corroded
  3. Metal debris on the sensor tip or reluctor ring
  4. Poor electrical connection
  5. Faulty transmission control module

How to diagnose & fix

Work through it in order

  1. Scan and confirm P0715, then read freeze-frame.
  2. Inspect the sensor connector and wiring for damage and corrosion.
  3. Remove and check the sensor for debris and the correct air gap.
  4. Measure the sensor's resistance/output against specification.
  5. Replace the sensor if faulty; verify the reluctor and TCM if the sensor is good.

FAQ

Quick answers

Is it safe to drive with P0715?+
Only briefly and gently β€” the transmission may limp or shift harshly without this signal, and extended driving can cause wear. Repair it soon.
Can I just clear P0715?+
It comes back as soon as the TCM loses the turbine speed signal again; the sensor or wiring must be repaired.

Related codes

Often seen with P0715

Read & clear P0715 yourself

Scan your car, confirm the code, and clear it once it's fixed β€” with OBD DashX on your phone.

β–Ά Get it on Google Play
βœ“ Verified name β€” SAE J2012 / ISO 15031-6Guidance reviewed by OBD DashX